Artesyn ARTM-9405 16x10GbE Installation and Use Guide (May 2014) - Manual (Page 20)

Hardware Preparation and Installation
ARTM-9405 16x10GbE Installation and Use (6806800P45F) 20
10. Fully insert the RTM and lock it to the shelf by pressing the two components of the lower
and upper handles together, and then turning the handles toward the face plate.
If your shelf is powered, as soon as the RTM is connected to the front blade, the blue LED
lights up and remains lit until the lower handle of the RTM and the lower handle of the front
blade are closed.
11. Close the lower handle of the front blade so that the payloads of the RTM and front blade
are powered up. The blue LEDs on both the front blade and RTM start flashing. This
indicates that the front blade is informing the shelf manager that it wants to power up the
payload of front blade and RTM.
12. Tighten the face plate screws on the RTM.
13. Wait until the blue LEDs on the front blade and the RTM are not lit. A blue LED that is not lit
indicates that the payload of the front blade and the RTM has been powered up and is
active.
14. Plug the interface cable into the face plate connectors, if applicable.