Desktop mounting instructions – ARRIS TG852G-NA User Guide User Manual
Page 23
23
Touchstone TG852 Telephony Gateway User’s Guide
1 Position the mounting template on the surface where you intend to mount
the Telephony Gateway and secure in place with transparent tape.
2 Drill holes through the template in the specified locations for the mounting
screws. After drilling holes, remove the template from the surface.
3 If using drywall anchors, set them into the wall. Then, drive the screws into
the wall leaving a gap of about 1/8” (3 mm) between the screw head and
the wall. If not using anchors, just drive the screws.
4 Orient the Telephony Gateway with the indicator lights facing up or right, as
desired. Slip both mounting slots (in the back of the Telephony Gateway)
over the screws, then slide the case down until the narrow end of the key-
hole slot contacts the screw shaft.
5 Proceed to
Connecting the Telephony Gateway
Desktop mounting instructions
1 Position the Telephony Gateway so that:
•
air flows freely around it
•
the back faces the nearest wall
•
it will not fall to the floor if bumped or moved
•
the ventilation holes on the side of the unit are not blocked.
2 Proceed to