Argox OS-2130D - Manual (Page 12)

10
OS-2130D & OS-2130DE User’s Manual
Main board DIP switch settings
Firmware version & date code
Memory capacity
Print method
Real Time Clock (RTC) setup
Internal fonts
Printed label length
Serial port settings
Print speed and darkness
Media type setting
Cutter setting
Peeler setting
Backfeed setting
Cutter/Peeler setting offset
Calibration Type
11
OS-2130D & OS-2130DE User’s Manual
Resetting Printer to Factory Defaults
Follow the steps below to reset printer to default settings:
1. Turn on the printer and wait for 5 or more seconds.
2. Press the "FEED" button for 10 seconds, and the "Ready"
indicator and "Power" indicator will go off in order.
3. Once "Power" indicator becomes lit again, release the FEED
button.
4. "Ready" indicator will then become lit, too. At this moment,
the printer has resumed its factory default settings.
Note:
The printer factory default settings are stored in printer’s flash;
these settings remain stored, without being erased even the printer
power is disconnected.