Analog Way LIVECORE PLATFORM TPP Current Programmer's Guide - Manual (Page 30)

30
PROGRAMMER'S GUIDE FOR v02.00.46
3.8 Configuring the Monitoring full screen mode
3.8.1 Usage
This command sequence sets the Monitoring output to full screen
mode, sets the full screen mode source and updates/refreshes the
Monitoring output.
3.8.2 Detailed commands sequence

Start the monitoring configuration change : Prepare the monitoring
for a new configuration by writing the value 0.
Syntax : , 0MLupd
L
F
is the device index (0 for Master device, 1 for Slave device).

Enable monitoring full screen mode : Enable full screen mode by
writing the value 1.
Syntax : , 1MLfen
L
F
is the device index (0 for Master device, 1 for Slave device).

Select source : Select the Monitoring source that will be displayed
(full screen).
Syntax : , MLfes
L
F
is the device index (0 for Master device, 1 for Slave device).
is the element source index:

Apply changes: This command updates the Monitoring.
Syntax : , 1MLupd
L
F
is the device index (0 for Master device, 1 for Slave device).
Monitoring source value
Input 1 of Master Device 0
…… …
Input 12 of Master Device 11
Input 1 of Slave Device 12
…… …
Input 12 of Slave Device 23
Frame 1 of Master Device 24
…… …
Frame 4 of Master Device 27
Frame 1 of Slave Device 28
…… …
Frame 4 of Slave Device 31
Logo 1 of Master Device 32
…… …
Logo 4 of Master Device 35
Logo 1 of Slave Device 36
…… …
Logo 4 of Slave Device 39
screen 1 40
…… …
screen 8 47
preview 1 48
…… …
preview 8 55