AMETEK SLM-4 - Manual (Page 75)

APPENDIX E
SLD-SERIES GPIB/RS-232
OPERATING FLOW CHART
The following flow chart shows the typical SLM-Series chassis remote control and load
current level and status setting procedures of each SLD-series load module.
START
CHANNEL 1? CHANNEL 4? CHANNEL 3? CHANNEL 2?
Set
"CHAN 1"
Set
"CHAN 4"
Set
"CHAN 3"
Set
"CHAN 2"
CC MODE? CR MODE? CV MODE?
Set
"MODE CC"
Set
"MODE CV"
Set
"MODE CR"
STATIC or
DYNAMIC?
Set
"DYN OFF"
"CC:NR2"
DYNAMIC
STATIC
YES
NO
NO
NO NO
NO
NO
NO
YES YES
YES YES YES YES
Set
"CHAN A"
Set
"CHAN B"
CHAN A or
CHAN B?
Set
"DYN ON"
"CC:HIGH NR2"
"CC:LOW NR2"
"PERI:HIGH NR2"
PERI:LOW NR2"
"SLEW NR2"
Set
"DYN OFF"
"CV:NR2"
Set
"DYN OFF"
"CR:NR2"
Module Setups
Load On/Off
Voltage
Set
"LDONV NR2"
"LDOFV NR2"
Vsense
Set
"SENS ON|OFF"
Good/No Good
Set
"NGAB ON|OFF"
"LIM:CURR:HIGH NR2"
"LIM:CURR:LOW NR2"
"LIM:VOLT:HIGH NR2"
"LIM:VOLT:LOW NR2"
Is CHB/ CHA
Set?
Set
"LOAD ON"
M540069-01 Rev B E-1