AMETEK SLM-4 - Manual (Page 28)

GPIB/RS-232 Programming Sorensen SLM-4 Chassis
The connections for the rear panel RS-232 interface are shown below; Figure 4–1a depicts the
connector wire diagram, and Figure 4–1b depicts the connections using a standard RS-232
cable.
RS-232C Port
On SLM Mainframe
TxD
Rxd
RTS
CTS
.
.
.
Inside the
SLM Mainframe
TxD
Rxd
RTS
CTS
DSR
GRN
DCD
DTR
PC RS-232C Port
TxD
Rxd
RTS
CTS
.
.
.
Fig. 4.1a Fig. 4.1b
2
3
4
5
6
7
8
9
RS-232C Port
On SLM Mainframe
TxD
Rxd
RTS
CTS
.
.
.
Inside the
SLM Mainframe
TxD
Rxd
RTS
CTS
DSR
GRN
DCD
DTR
PC RS-232C Port
TxD
Rxd
RTS
CTS
.
.
.
Fig. 4.1a Fig. 4.1b
2
3
4
5
6
7
8
9
Figure 4–1 RS-232 Interface Diagram
The following RS-232 setting commands are channel-dependent commands except ”CHAN”
which is a channel-specific command; therefore, for proper program execution ”CHAN” should
be sent first, and then the channel-dependent command.
For example:
Short ON of Channel 1 of SL-series Electronic Load module, the RS-232 programming
command is: CHAN 1;SHOR ON.
As with the GPIB commands, the following RS-232 commands with [GLOB:] option can set all
the SL-series Electronic load modules in the SLM chassis to be active simultaneously. This
feature can greatly reduce the testing time and increase efficiency.
4.4 GPIB/RS-232C COMMAND LIST
4.4.1 Command Syntax Abbreviations
SP :Space, the ASCII code is 20 Hexadecimal.
;
:Semicolon, Program line terminator, the ASCII code is OA Hexadecimal.
NL :New line, Program line terminator, the ASCII code is OA Hexadecimal.
N :Integer from 1 to 8.
NR2 :Digits with decimal point. It can be accepted in the range and format of ##.#####.
Example:
30.12345, 5.0
4-2 M540069-01 Rev B