AMETEK SLM-4 - Manual (Page 17)

SECTION 2
CONFIGURATION AND
MAINTENANCE
2.1 INSPECTION
The SLM-4 chassis was carefully inspected before shipment. If instrument damage has
occurred during transport, please inform the Xantrex sales and service office or representative
per the Warranty instructions of this manual. SLM-4 chassis was shipped with a power cord for
the type of outlet used at your location. If the appropriate cord was not included, please contact
your nearest Xantrex sales representative to obtain the correct cord. Refer to Section 2.1.1 to
check the line voltage selection and fuse type.
2.1.1 Line Voltage
The SLM-4 chassis and SL-series electronic loads can operate with 100, 115, 200 or 230VAC
input as indicated on the label on the rear panel (Figure 2–1). Make sure that the factory check
mark corresponds to your nominal line voltage. If not correctly marked, perform the following
procedures:
1. With the mainframe power OFF, disconnect the power cord.
2. Set the switches on the rear panel to the proper voltage as follows:
a. Set Switch to 100V/115V for 100Vac or 115Vac line voltage
b. Set Switch to 200V/230V for 200Vac or 230Vac
M540069-01 Rev B 2-1