AMETEK DCS-E 1kW Series Programming Manual User Manual
Dcs-e 1kw series, dlm-e 3kw & 4kw, Power supplie
This manual is related to the following products:
Table of contents
Document Outline
- DCS-E 1kW Series, DLM-E 3kW & 4kW Power SuppliesM51A Option: Isolated Analog Programming Manual
- SECTION 1 M51A OPTION OVERVIEW
- SECTION 2 ISOLATED ANALOG PROGRAMMER OPERATION
- 2.1 SW1 Switch
- 2.2 ISOLATED ANALOG PROGRAMMER Connector (J4)
- 2.3 Remote Programming Configuration
- 2.3.1 Voltage Source Programming of Output Voltage
- 2.3.2 Voltage Source Programming of Output Current
- 2.3.3 Voltage Source Programming of OVP
- 2.3.4 Resistance Programming of Output Voltage
- 2.3.5 Resistance Programming of Output Current
- 2.3.6 Resistance Programming of OVP
- 2.3.7 4-20mA Current Source Programming of Output Voltage
- 2.3.8 4-20mA Current Source Programming of Output Current
- 2.3.9 Programming the Shutdown Function
- 2.3.10 TTL Shutdown
- 2.3.11 Shutdown Application – Contact Closure
- 2.3.12 Local/Remote Application
- 2.4 Remote Monitoring
- 2.5 Remote Digital Status Signals