AMETEK DCS-E 1kW Series Programming Manual - Manual (Page 15)

DLM-E Series and DCS-E Series Isolated Analog Programmer Operation
2.2 ISOLATED ANALOG PROGRAMMER Connector (J4)
The ISOLATED ANALOG PROGRAMMER connector is a 25-position female
Subminiature-D type. The table below defines each pins function.
Pin Function
1 ANALOG-CONTROL input
2 Isolated Analog Common
3 OVP programming input
4 Voltage monitor output, 4-20mA
5 VOLTAGE-MODE status output
6 Isolated Analog Common
7 Current monitor output, 0-5/10V
8 4-20mA voltage programming offset signal (-2.5VDC)
9 Voltage programming input, 0-5/10V
10 Current programming input, 0-5/10V
11 4-20mA current programming offset signal (-2.5VDC)
12 Isolated Analog Common
13 Return for 4-20mA current programming signal
14 Shut-Down input
15 Auxiliary 16VDC output (+)
16 OVP resistance programming output, 1mA source
17 OVP status output
18 FAULT status output
19 Voltage monitor output, 0-5/10V
20 Input for 4-20mA current programming offset signal (-2.5VDC)
21 Voltage resistance programming output, 1mA source
22 Current resistance programming output, 1mA source
23 Input for 4-20mA current programming offset signal (-2.5VDC)
24 Current monitor output, 4-20mA
25 Return for 4-20mA voltage programming
Table 2–2. ISOLATED ANALOG PROGRAMMER Connector Pinout
CAUTION
The signals of the ISOLATED ANALOG PROGRAMMER have an
internal connection to chassis ground. Damage could result if the
voltage from signal returns, Pin-2, 6, 12, 13, and 25 to chassis ground
exceeds 60VDC.
M51A Option 2-3