Adtec digital YUV2QAM (version 01.02.01) Manual - Manual (Page 19)

Services Menu
Items under the denoted << CH 1 - CH 2 >> parallel menu are unique to each encoder.
Control/Setting Function Options API Command
Tx Mux Rate Configures the transport stream
multiplex rate when operating in
Annex A mode. ***This rate is
configured automatically when
operating in Annex B mode.
1 - 100
Mbit/s *.ECMD0 TMR
Video Auto Fill When enabled the encoders bit rate
will automatically be adjusted to
maximize available bandwidth.
On / Off *.ECMD0 VAF
<< CH 1 - CH 2 >>
Video Rate Configure each channels video encode
rate. *** Video Rate can only be
configured when Video Autofill is set
to Off.
*.ECMD0 VRT
Short Name When using ATSC, this field is
referred to as Short Name. When
using DVB, it is referred to as Service
Name.
text field;
7-character
limit.
*.ECMD# SNA
Long Name When using ATSC, this field is
referred to as Long Name. When
using DVB, it is referred to as Service
Provider.
text field;
20-
character
limit.
*.ECMD# SPR
Major Channel
Number
Configures major channel number for
ATSC.
*** Setting this value to zero will
enable single-part channel number
mode.
text field;
0-999
available
see note
below table
*.ECMD# MAJ
Minor Channel
Number Configures minor channel number for
ATSC.
*** Is the Channel number single-
part mode.
text field;
0-999
available
*.ECMD# MIN
Input Configures the active input type YUV
Composite *.ECMD# INP
Start Up Determines whether or not the
Channel is active. It is recommended
to set this to OFF for single channel
mode operation.
On
Off *.ECMD# STU