Digi PortServer TS8 - Manual (Page 97)

PortServer TS 8/16 Troubleshooting 17-7
For controlled TFTP access, make sure that the file /etc/tftpaccess.ctl exists and verify that it
only allows access to public directories. If this file is not present, tftp will allow full access. A
sample file is located in the directory /usr/lpp/tcpip/samples.
• Restart the inetd process with these two commands:
ps -ef | grep inetd
This will report back the inetd process number.
Kill -1 inetd_PID
Where inetd_PID is the process number for the inetd process reported by the previous command.
Resetting PortServer TS 8/16 Configuration to Defaults
Use this topic to reset the PortServer TS 8/16 configuration to defaults.
Note: This procedure causes the PortServer TS 8/16 to lose all configuration changes. If you
have a complex configuration, see the cpconf command in the Digi One/PortServer TS
Command Reference for information on backing up your configuration.
Command Line Procedure
1. Log on to the PortServer TS 8/16 as root.
2. Issue the following command:
boot action=factory
Front Panel Procedure
1. Power on the PortServer TS 8/16
2. While the PortServer TS 8/16 is still booting, press and hold (for about 10 seconds) the white
button on the front panel.