Digi PortServer TS8 - Manual (Page 86)

17-2 Terminal Server Configuration Without RealPort
Terminal Server Configuration Without RealPort
In this configuration, PortServer TS 8/16 functions as a terminal server, providing Telnet and Rlogin
access to hosts. This configuration enables the following:
•
Telnet or Rlogin access to the LAN-based hosts, both from locally-connected terminals and from
devices accessing the LAN from the telephone network.
• Access for the LAN-based hosts to PortServer TS 8/16 ports (sometimes called reverse Telnet)
Related Information
For more information on configuring
•
The Ethernet interface, see "Configuring the IP Address" on page 2-1.
• Terminal connections, see "Configuring Ports for Terminals and Computers" on page 6-1.
• Modem connections, see "Configuring Ports for Modems" on page 5-1.
Illustration
Configuration
set config ip=19 2.250.150.10 submask=255.255.255.0 (1)
set ports range=1-2 dev=term
set line range=1-2 baud=9600
set flow range=1-2 ixon=on ixoff=on (2)
set ports range=3-4 dev=mio
set line range=3-4 baud=115200
set flow range=3-4 ixon=off ixoff=off rts=on cts=on (3)
set user name=user1 (4)
Configuration Notes
1. The set config command configures the IP address and mask for the PortServer TS 8/16 Ethernet
interface.
2. The first set ports, set line, and set flow commands configure ports 1 and 2 for terminal connec-
tions.
3. The next set ports, set line and set flow commands configure the ports for bidirectional modems.
Software flow control (the default) is explicitly shut off and hardware flow control turned on
using the set flow command.
4. The set user command defines a user, which assigns a user name for login purposes. All PortS-
erver TS 8/16 users can login with this name.
Host
Terminals
192.250.150.10
192.250.150.9
Modems
Digi Device
Host
192.250.150.17