Options for configuring the ip address and mask -2, Options for configuring the ip address and mask – Digi PortServer TS8 User Manual
Page 14
2-2
Options for Configuring the IP Address and Mask
Options for Configuring the IP Address and Mask
Options
The PortServer TS 8/16 IP address can be configured using the following methods:
•
With Digi Port Authority-Remote, a Digi utility
•
By updating the ARP table on a server and then pinging the Digi device (called Ping-ARP)
•
From the command line using the set config command
•
Using a RARP server
•
Using a DHCP server
The IP address and mask can also be changed using the web interface. This method, however, does
not work for the initial IP address configuration.
Devices That Support DPA-Remote and Ping-ARP for IP Address Configuration
Not all Digi devices can use DPA-Remote and Ping-ARP for IP address configuration. To determine
if you can use these features, find the hardware label on your Digi device and then use the table
below to determine whether this feature is available:
Device
Part Number
Revision Required
PortServer TS 8
50001208-01
B or higher
PortServer TS 16 (desktop)
50001207-01
E or higher
PortServer TS 16 (rack-mounted)
50001185-01
C or higher