Configuration procedures -3, Configuration procedures – Digi PortServer TS8 User Manual
Page 69
Configuring DNS
13-3
Configuration Procedures
Procedure for Using a Name Server
To configure a DNS server, enter the following command:
set config domain= domain myname=name dns=ip-address
where
•
domain is the domain in which the PortServer TS 8/16 will reside
•
name is a DNS name for PortServer TS 8/16
•
ip-address is the IP address of a name server
Example:
set config domain=digi.com myname=poe dns=204.221.1.4
Procedure for Using a Host File
Use this section to configure the host table, which maps IP addresses to host names.
Enter the following command
set host name= name ip=ip-address
where
•
name is the name the host
•
ip-address is the IP address of the host
Example
In this example, three IP address-to-name mappings are configured
set host name=poe ip=204.221.110.200
set host name=gary ip=204.221.110.202
set host name=toni ip=204.221.110.203