Digi PortServer TS8 - Manual (Page 64)

12-6 Using RADIUS to Authenticate Users
Configuring RADIUS: Command Line
To configure PortServer TS 8/16 to function as a RADIUS client, supply a set radius command
that specifies the following:
•
run=on
• The IP address of the primary RADIUS server (on the primary field). The primary server is the
first server to which authentication requests are sent.
• A password (on the secret field)
Note To use a secondary RADIUS server, supply a second set radius command that specifies run=on ,
the IP address of the secondary server (on the secondary field) and another password for the
secondary server (on the secret field).
RADIUS Command Line Configuration Example
set radius run=on primary=199.123.15.129 secret=J9CxegpP