Adamson SpekTrix - Manual (Page 45)

SpekTrix Series User Manual 45 of 72
4.2 Flying the Array
1. Lift slightly and confirm frame angle using inclinometer and laser. When using a 2 point hang with the SpekTrix,
you can adjust the frame angle using the motors once it is fully up in the air.
2. Loop the measuring tape to the bottom handle of the array, lift to the desired trim height and release the
measuring tape when ready. Remember to double up the lenght when using a “loop” method.
You can also use a piece of tape to attach it to the bottom enclosure, and pull the measuring tape out when
ready. (Note: This method might leave an awkward piece of tape hanging off the bottom box)
. Check angle once in proper trim height to confirm planned coverage.
1. 2. & 3.