Xtramus NuOutlet-LN V1.1 - Manual (Page 35)

35
(i) Select Crossing Mode in different degrees or free run (any point) only in power on or off
status.
(ii) Click on Apply button to activate the crossing mode.
(iii) Click the radio button to select Cycle Reboot mode.
(iv) Set Cycle Reboot Configuration in Burst, Continue or Multi-Burst mode.
(v) Then enter power reboot interval (in seconds) and count values (in times) in the fields.
3. Press OK to apply all the changes you’ve made and exit Device Control window, press Cancel to
cancel all the changes you’ve made and exit, or press Apply to apply all the changes you’ve made
without closing the Device Control window.
Note: Power cycle reboot (relay count) can reach up to 100 times per second.
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®