Xtramus MCS-2160 V1.9.2 - Manual (Page 14)

B. System Module Card – XM-M667
The XC-M667 comes with your MCS-2160 chassis, and shall be installed on the Mgm slot located on
the far right side of MCS-2160 chassis. This module card allows you to manage MCS-2160 chassis
via management webpage.
To access the Management Web Page of MCS-2160 for configuration on your browser, please
connect a RJ45 cable between the Management port of MCS-2160 and your PC.
To configure MCS-2160 on your PC (Telnet or Hyper Terminal), please connect a 2.5mm Phone Jack
to RS232 between your PC and Console Port of MCS-2160, where the 2.5mm Phone Jack end must
be plug in the Console Port of MCS-2160 and the RS232 end must be connect to your PC.
Interface Ports
Console Port One 2.5mm Phone Jack Port for managing MCS-2160 via HyperTerminal
Management Port One 10/100M RJ45 Port for managing MCS-2160 via management webpage
LED
Green ON XC-M667 is power on
Power
Green OFF XC-M667is power off
Yellow ON
XC-M667 is booting and preparing for test
Green ON
(Blinking)
XC-M667 is booting properly and is ready for test Sys
Green OFF XC-M667 is power off
Master User defined LED
Remote User defined LED
*Note: XC-M667 does not support hot-swap. Please do not draw the XC-M667 module card from MCS-2160
chassis when the system is power on.
14
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®