Vectronics VEC-841K - Manual (Page 10)

VEC-841K Owner's Manual Tunable SSB/CW Audio Filter Kit
7
STEP-BY-STEP ASSEMBLY
Before assembling your kit, please take time to read and understand the VEC kit
warranty printed on the inside cover of this manual. Also, read through the
assembly instructions to make sure the kit does not exceed your skill level. Once
you begin construction, your kit will be non-returnable. Finally, if you haven't
already done so, please verify that all parts listed in the inventory are included.
If anything is missing or broken, refer to the warranty instructions for replacing
missing or damaged parts.
Note that part designators, such as R1, C3, etc., appear on a silk-screened legend
on the component-mounting side of the printed circuit board. This corresponds
with the parts placement page in the manual. All parts will be inserted on the
silk-screen side of the board.
If you have last-minute questions about what you need to build your kit, please
refer back to the section titled "Tools and Supplies". If you're ready to begin
now, here we go! The directions use two sets of check boxes. Check one when
a step is complete and use the other for double-checking your work before
operation.
Installing Resistors:
! ! 1. Locate resistor R35. This is a 2.7 ohm resistor (red-violet-gold).
Carefully bend the leads close to the resistor body to form right-angles (see
following diagram).
.4"
! ! 2. Insert R35 into its mounting holes so the resistor body rests against the
board. Solder in place and trim the leads.
! ! 3. Locate resistor R10. This is a 470 ohm resistor (yellow-violet-brown).
Carefully bend the leads close to the resistor body as in Step #1. Insert
at R10, solder in place and trim the leads
! ! 4. Locate resistor R28. This is a 470 ohm resistor (yellow-violet-brown).
Carefully bend the leads close to the resistor body as in Step #1. Insert
at R28, solder in place and trim the leads.
! ! 5. Locate resistor R29. This is a 470 ohm resistor (yellow-violet-brown).
Carefully bend the leads close to the resistor body as in Step #1. Insert
at R29, solder in place and trim the leads.