Controls & functions, Lvm-095w : front – TVLogic LVM-095W-N User Manual
Page 8

8 Multi Format LCD Monitor
LVM-095W : FRONT
3. Controls & Functions
• [SDI] Button/Lamp
- Used to select SDI-A/B input.
• [HDMI] Button/Lamp
- Used to select HDMI input.
• [SCAN] Button/Lamp
- Used to change the scan mode.
- Press the button to activate through the scan
modes: [ZEROSCAN] -> [OVERSCAN] -> [PIXEL
TO PIXEL] -> [USER ASPECT] -> [ZEROSCAN]
* PIXEL TO PIXEL mode is not available in
graphic mode.
* [USER ASPECT]: User can adjust width and
height of the display.
* Check “7. Other Functions [1] User Aspect” for
more information.
• [ASPECT] Button/Lamp
- Used to change the various display ratio.
Activates in order of [16:9] – [4:3] – [2.35:1] -
[1.85:1] – [15:9] – [16:10] – [AUTO] – [16:9].
• [MARKER] Button/Lamp
- Used to activate/deactivate the Marker. The
type of marker at work can be selected on the
main menu.
• [HVDELAY] Button/Lamp
- Used to check horizontal sync and vertical
sync simultaneously by moving the display
left, right, up and down.
- In this mode, the brightness of the image
automatically increase for easy verification of
synchronized signals.
• [BLUE]/[MONO] Button/Lamp
- Activates in the order of [Off]-[Blue Only]-
[Mono]-[Off]
- Press the button to remove red and green
from the input signal and display the screen
only under a blue signal. Press the button
again to activate mono mode.
• [Waveform/VECTOR] Button/Lamp
- Used to activate/deactivate the Waveform.
- The type of Waveform at work can be selected
on the main menu.
• [F1][F2][F3] Button/Lamp
- Used to activate the [F1]~[F3] function.