TVLogic LVM-095W-N - Manual (Page 19)

Multi Format LCD Monitor 19
• Line Select Enable
- Used to select specific Vertical Line for
Waveform/Vectorscope.
- It is available when LINE Waveform is
activated.
- To activate this feature, press the [W-FORM/
VECTOR] Button, then use the [UP]/[DOWN]
Button to select a desired vertical line.
- Control range varies according to the
resolution of the input SDI signal.
* 576i : Min. 1, Max. 625
* 480i : Min. 1, Max. 525
* 720p : Min. 1, Max. 750
* 1080i : Min. 1, Max. 1125
* 1080p : Min. 1, Max. 1125
[5] Waveform
5. Menu Operations
• Luma(Y’) Zone Check
- Displays the Luma(Y’) level of the input image
in colors.
- May select between [Color Pattern] or [Zebra
Pattern].
- Each pixel’s Y’ analized and changed to a certain
color or zebra pattern according to the Index on
the right side of the screen.
- When a pixel’s Y’ level is under 0%(16), the color /
diagonal line will be colored Green.
- When the pixel’s Y’ level is over 100%(235), the
color / diagonal line will be colored Red.
- When the Y’ level of a pixel is between 0~100%,
the pixel is displayed with Gray, except for
selected Luma Zone.
- In the [Color Pattern] mode, a 5% zone of the
selected Y’ level will be colored Pink(5%) and
±10% will be colored Yellow(-10% from Pink) and
Cyan(+10% from Pink).
- In the [Zebra Pattern] mode, ± 5% of the selected
Y’ Level will be displayed with diagonal lines.
• Luma(Y’) Zone Adjust
- Used to set the Y’ level to be colored Yellow,
Pink and Cyan in [Color Pattern] mode, or to
set Y’ level zone to be displayed with diagonal
lines in [Zebra Pattern] mode.
- Available values are 0 ~ 100%.
* See section “7. Other Functions -> [5] Luma(Y’)
Zone Check” for more information.