Tview D65TSG - Manual (Page 38)

38
• Tap to open the list of results before it
appears automatically.
4. Pick the settlement from the list.
4. Enter the street name:
1. Tap .
2. Start entering the street name on the keyboard.
3. Get to the list of results:
• After entering a couple of characters, the names that match the string
appear in a list.
• Tap to open the list of results before it appears
automatically.
4. Pick the street from the list.
5. Tap the button.
• If only a few intersecting streets exist, their list appears immediately.
• In case of a longer street, a keyboard screen appears. Start entering the name
of the intersecting street on the keyboard. As you type, if the matching streets
can be shown on one screen, their list appears automatically.
6. Tap the desired intersecting street in the list.
7. The map appears with the selected point in the middle. Tap
(Simple mode) or (Advanced mode) from the Cursor menu. The
route is then automatically calculated, and you can start navigating.
3.1.2.6 Selecting a city centre as the destination
The City Centre is not the geometric centre of the settlement but an arbitrary point the map
creators have chosen. In towns and villages, it is usually the most important intersection; in
larger cities, it is an important intersection.
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons: (Simple mode), or , (Advanced
mode).
2. By default, Nav N Go iGO 8 proposes the country/state and settlement where you are.
If needed, tap the button with the name of the country/state, and select a different one
from the list.
3. If needed, change the settlement:
• To select the settlement from the list of recently used ones, tap the
button.
• To enter a new settlement: