Tview D65TSG - Manual (Page 35)

35
7. The map appears with the selected point in the middle. Tap
(Simple mode) or (Advanced mode) from the Cursor menu. The
route is then automatically calculated, and you can start navigating.
3.1.2.3 Entering an address if house numbering is restarted
There are long roads where the house numbering is restarted at some point. This way the
same house number can appear twice or even more times on the same road. If this is the
case, after giving the house number, you need to select the appropriate address by the
district/suburb information.
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons: (Simple mode), or , (Advanced
mode).
2. By default, Nav N Go iGO 8 proposes the country/state and settlement where you are.
If needed, tap the button with the name of the country/state, and select a different one
from the list.
3. If needed, change the settlement:
• To select the settlement from the list of recently used ones, tap the
button.
• To enter a new settlement:
1. Tap the button with the name of the settlement, or if you have changed
the country/state, tap .
2. Start entering the settlement name on the keyboard.
3. Get to the list of search results:
• After entering a couple of characters, the names that match the
string appear in a list.
• Tap to open the list of results before it
appears automatically.
4. Pick the settlement from the list.
4. Enter the street name:
1. Tap .
2. Start entering the street name on the keyboard.
3. Get to the list of results:
• After entering a couple of characters, the names that match the string
appear in a list.
• Tap to open the list of results before it appears
automatically.