Thor V3 Decoder - ASI, IP, RF - Closed Captions - Manual (Page 23)

Chapter
Network Management System Profile
In addition to the front panel LCD interface, the unit can also be managed and configured
through any standard modern web browser. The default IP address is typically
192.168.1.136, however this may be modified during configuration
unit’s management IP address can be easily set or identified from the front panel interface.
Please refer to the previous section for assistance.
Chapter
THOR’ several levels of inspection for quality control. All systems shipped by Thor are
fully tested and visually inspected after manufacture. Additionally, all units are
re-inspected and pre-configured prior to shipping. Under most circumstances, Thor offer
free configuration service for most equipment. Thor can set operating parameters prior to
shipping, and ensure trouble free operation and installation.
Prevention Measure
Please ensure that the environment remains within
Provide adequate ventilation to the heat sinks and side vents.
Check the input AC voltage, please use appropriate power supplies
Check that all signal cables are securely installed and nothing is loose.
Frequently switching on/off device is
seconds between power cycles.
H-HD-IRD
21
Chapter 4NMS Setting
Network Management System Profile
In addition to the front panel LCD interface, the unit can also be managed and configured
through any standard modern web browser. The default IP address is typically
192.168.1.136, however this may be modified during configuration prior to shipping. The
s management IP address can be easily set or identified from the front panel interface.
Please refer to the previous section for assistance.
Chapter 5 Troubleshooting
several levels of inspection for quality control. All systems shipped by Thor are
fully tested and visually inspected after manufacture. Additionally, all units are
configured prior to shipping. Under most circumstances, Thor offer
free configuration service for most equipment. Thor can set operating parameters prior to
trouble free operation and installation.
Please ensure that the environment remains within 0 to 45 °C
ntilation to the heat sinks and side vents.
, please use appropriate power supplies
Check that all signal cables are securely installed and nothing is loose.
Frequently switching on/off device is not recommended. Please allow at least 10
seconds between power cycles.
IRD-V3 User Manual
In addition to the front panel LCD interface, the unit can also be managed and configured
through any standard modern web browser. The default IP address is typically
prior to shipping. The
s management IP address can be easily set or identified from the front panel interface.
several levels of inspection for quality control. All systems shipped by Thor are
fully tested and visually inspected after manufacture. Additionally, all units are
configured prior to shipping. Under most circumstances, Thor offers
free configuration service for most equipment. Thor can set operating parameters prior to
not recommended. Please allow at least 10