Thor 2 mW CATV RF Over Fiber Tx 45-870 MHz - Manual

1
FOREWORD
This manual is applicable to the Thor Series F-RF 1310nm Transmitters for 900 MHz signals.
This guide describes the product's function characteristics, technique parameters, installation and
debugging procedures. For insuring the equipment can be successfully installed and safely work,
please carefully read the manual before using this equipment, and adhere strictly to the
prescriptive operation steps of this manual for installation and debugging. This will prevent
unnecessary damage to the equipment or harm to the operator. If there is question, please contact
Thor directly.
Special Notice:
1. The optical transmitter is professional broadcast equipment, and its installation and
debugging must be performed by special technician. Users should read this manual before
operating to prevent damage to the equipment by faulty operation or human injury.
2. There is invisible laser bean from Fiber output, which if direct shined at eyes will cause
permanent damage.
3. Earthing first before turning on the power and being sure that the rack mount and the outlet
are earthed as well (Earthing resistance should be less than 4Ω), will prevent damage to the
laser by static.
4. For insuring the equipment can work stably for the long-term, please insure that the input
voltage is of a stable waveform, in some cases it may be necessary to use a UPS power
supply to provide constant and steady power. The environmental conditions are also very
important for the longevity of the equipment. Ideal conditions are 25 degrees Celsius with
low humidity.