Thor V3 Decoder - ASI, IP, RF - Closed Captions User Manual

Page 12

1PPS& 10MHz Input and Loop

2.4.2HD-IRD-V3 HD IRD Satellite Receiver Signal Cable Connection

Illustration:

RF IN and LOOP OUT Connection Illustration:

Users can find the RF IN and LOOP OUT interface on the device according to the

connector mark described on the rear panel illustration

One end is connected to the RF IN interface of

connected to the satellite signal source equipment or LOOP OUT interface of the previous

satellite receiver when several satellite receivers are series connection. As follows:

ASI IN and ASI OUT Connection Illustration:

Users can find the ASI IN and ASI OUT

mark described on the rear panel illustration

connected to ASI IN interface of the HD IRD

H-HD-IRD

Loop-outCable Illustration

HD IRD Satellite Receiver Signal Cable Connection

Connection Illustration:

Users can find the RF IN and LOOP OUT interface on the device according to the

described on the rear panel illustration, connect the cable as shown below

RF IN interface of satellite receiver while the other end

connected to the satellite signal source equipment or LOOP OUT interface of the previous

satellite receiver when several satellite receivers are series connection. As follows:

Connection Illustration:

ASI OUT interface on the device according to the connector

described on the rear panel illustration,connect the cable as shown. One end is

of the HD IRD, the other end is connected to any device that

IRD-V3 User Manual

HD IRD Satellite Receiver Signal Cable Connection

Users can find the RF IN and LOOP OUT interface on the device according to the

as shown below.

satellite receiver while the other end is

connected to the satellite signal source equipment or LOOP OUT interface of the previous

satellite receiver when several satellite receivers are series connection. As follows:

interface on the device according to the connector

. One end is

, the other end is connected to any device that