Thor 1-4 HDMI to ATSC Modulators 8VSB - Manual (Page 10)

H-4HDMI-ATSC-IP
Chapter 2 Installation Guide
2.1 General Precautions
 Must be operated and maintained in an area free of dust and debris.
 The cover should be securely fastened, do not open the cover of the chassis when the
power is on. This will also void Thor’s manufacturer’s warranty.
 After installation, securely stow away all loose cables, external antenna, and others.
2.2 Power Precautions

Be careful when connecting a power source to the device.

Do not operate in wet or damp areas. Make sure the extension cable is in good
condition

Make sure the power switch is off before you start to install the device
2.3 Device’s Installation Flow Chart Illustrated as following
Connecting
Groud Wire
and Power
Cord
Acquisition
Check
Installing
Device
Setting
Parameter
Running
Device
Connecting
Signal
cable
2.4 Environment Requirement
Item Requirement
Rack Mount
When user installs machine on rack, the distance between 2
rows of machine frames should be 1.2~1.5m and the distance
against wall should be no less than 0.8m.
Floor/ Table
Electric Isolation, Dust Free
Volume resistivity of ground anti-static material:
1X10
7
~1X10
10  ，Grounding current limiting resistance: 1M 
(Floor bearing should be greater than 450Kg/㎡)