Televes Serie H-60 - Manual (Page 69)

69
EN
- Disconnecting time -
When the user-programmed disconnecting time has gone by with the equipment inactive, a
message will appear on screen reading
Automat. Disconnect. along with a progress bar and a
sound signal indicating that the equipment is about to turn off.
When the progress bar achieves 100%, the equipment will turn off. The user may cancel the
equipment turning off process by punching any key, which will reactivate the programmed
inactivity cutoff period.
3.3.2.4.- Monitor parameters
This groups the functions controlling monitor parameters: volume, brightness, contrast,
color and high visibility.
The window appearing when enabling these functions is similar in every case. It is a horizontal
bar whose length varies with the level of the selected parameter. To vary the value of these
parameters you may use the . To accept the selected value, you may use the button
and to cancel the selection and close windows, you may use key .
Once the user-programmed disconnecting time has gone by, if a Macromeasure is
being executed, the meter will wait until the end of the measure to proceed with
automatic disconnection.
01031052_002_EN:103130_00.qxd 10/07/2013 8:00 Página 69