Televes Serie H-60 - Manual (Page 32)

32
Measures Config.
3.3.1.2.2.- Extra Burst
The selection of this option provides a power voltage increase of 1V for a voltage of 13V (14V)
and of 1.5V for a voltage of 18V (19.5V).
The extra burst is applicable both for terrestrial and satellite.
- Powering with Extra Burst -
3.3.1.2.3.- DiSEqC
The DiSEqC protocol enables working with up to 16 input multi-switches. For the purpose, and
with the meter on the
satellite band , on the power menu one should enable the voltage and tone
corresponding to the required polarity and band of the satellite.
As well as the chosen polarity and band, the multi-switch should be provided with information
on the satellite we intend to work with (the multi-switches group the different polarities in groups
=> The equipment detects voltage in the coaxial cable. In this case, the message that
will appear is " Vext ". This situation should be avoided.
=> When the equipment detects a short circuit, it emits a sound signal, and the
message appearing in this case is " Short Circuit ".
=> When the power consumption exceeds the maximum value allowed, the
message appearing is " Límit Exceeded ".
In the last two cases, the power is cut off, and automatic attempts at re-establishing it
are made every 3 seconds, approximately.
01031052_002_EN:103130_00.qxd 10/07/2013 8:00 Página 32