Network config, Factory defaults, Save and exit – TEKVOX TekManager Comprehensive User Manual
Page 51: Reset, Quit
TekManager Comprehensive User Manual
V040813
TEKVOX, Inc.
– 512.808.0845
Austin, TX 78746
51
Network Config
The “network config” command allows for editing the network configuration settings. These settings begin
with the unit IP address, each octet is displayed allowing a new value to be entered, or just accepting the
current value by depressing the enter key. An entered IP value of 0.0.0.0 defines DHCP mode. Once the
IP address is entered, Gateway and Subnet masks may be entered or modified in the same manner.
Values entered are not permanently stored until the
“Save and Exit” command is executed.
Factory Defaults
The “Factory Defaults” command resets all setup values to their initial defaults.
DHCP mode = enabled
SMTP port = 25
TEKPATROL port = 5070
TEKCONTROL port = 5072
PASSCODE = 6373
Serial Port 1 = 9600,N,1
SerialPort2 = 9600,N,1
Save and Exit
The “Save and Exit” command forces a save of data to the TekMonitor non-volatile storage area. Once
saved, the unit is reset, disconnecting the USB channel. The TekDebug program will have to be
restarted in order to reestablish connection.
Reset
The “Reset” command forces a reset of the TekMonitor resulting in a disconnection of the USB channel.
The TekDebug program will have to be restarted in order to reestablish connection.
Quit
The “Quit” command disconnects the USB channel, and the TekDebug program will have to be restarted
in order to reestablish connection.