Proceed PMDT - Manual (Page 20)

20
~ ac
mains
CLASS 1
LASER PRODUCT
No User Serviceable Components Inside. For service, contact Madrigal Audio
Laboratories or an Authorized Dealer. Any modifications to this equipment will void all warranties.
Apparatus Claims of U.S. Patent Nos. 4,631,603; 4,577,216;
4,819,098 and 4,907,093 licensed for limited viewing uses only.
S/N
designed and manufactured in USA
www.madrigal.com
m o d u l a r D V D t r a n s p o r t
BEFORE ATTEMPTING TO OPERATE THIS
DEVICE, REFER TO OWNER'S MANUAL FOR PROPER
OPERATING INSTRUCTIONS AND SAFETY PRECAUTIONS.
HAZARDOUS VOLTAGE AVAILABLE INSIDE; DISCONNECT
AC ~ MAINS CABLE BEFORE OPENING UNIT.
WARNING:
232
trigger
in
control ports PHASTLink
compatable
remote
ir
digital
audio outputs video
S video
composite
composite
video
Y/R
Pb/G
Pr/B
video video
Pb/B
P
r/R
Y/G
s-v
ideo
c
o
m
posit
e
c
o
m
posit
e
2 1 3 4 5 6 7 8 9
Rear Panel, PMDT
1 ~ AC MAINS CONNECTOR
The latching AC power switch on the front panel disconnects the PMDT
from the wall outlet’s AC power. Check to ensure that the power switch
is disengaged (protruding from the front panel), then plug the supplied
three-prong power cord into the AC mains receptacle before plugging
the power cord into the wall. (If a longer AC power cord is required for
your application, be sure to use a three-conductor power cord which
conforms to IEC standards.) Once the connections are all firmly made,
switch on power at the front panel. After a few moments of self-test, the
PMDT will enter
standby mode. Pressing the standby button will make it
ready for use.
The PMDT is designed to be left in standby when not in use, rather than
completely “off.” Being in standby allows it to respond to commands
from the remote control and maintains a stable operating temperature at
all times for optimal performance and longevity.
The Proceed PMDT has been safety-tested and is designed
for operation with a three-conductor power cord. Do not
defeat the “third pin” or earth ground of the AC power cord.
2 COMMUNICATIONS CARD
The PMDT provides for robust communications between components
using this card.