Appendix “a – Pinnacle Systems MG User Manual
Page 37
Slave Found
SLAVE microprocessor has sent an error code
to the MASTER and the MASTER is displaying
it. Any one the following error messages can
also be sent by the SLAVE. Also, you see this
message when the SLAVE is sending back error
codes from the memory chip during the power up
reset sequence.
UNKNOWN CODE
The MASTER has received an error code from
the SLAVE for which it has no match. It is possible
that the software versions don’t match.
Waiting for reset button
Master is waiting for user to push the RESET
button to start scanning. This indicates that you
pushed the RESET button too soon after getting
an error message and prevented the SLAVE from
saving the error code in permanent memory. You
should wait until the message displays one time
before pushing the RESET button.
Watchdog failure reset
MASTER has reset due to either a power loss or
some condition that caused the SLAVE to lockup,
in which case the watchdog reset it.
Appendix “A”
Diagnostics and Troubleshooting
A-5