Pengo RevTrak - Manual (Page 9)

PENGO RevTrak Manual 9
1) LC Display
Monochrome CAN-based display module with a 5.7” FSTN screen. Input power supply range from 9 V to 60 V. Operating
temperature range of -20 C to +65 C. Display has two circular 5-pin connections.
2) CAN Logger
CAN logger enables CAN messages to be recorded without a connection to a PC. The data is recorded and stored on a
SD memory card that can be opened by any PC. The CAN logger uses a 16-bit controller with flash memory. All data is
recorded in .csv format. .csv file can be analyzed and formatted using Microsoft® Excel.
3) Controller
DVC7 programmable valve controller stores all pre programed Anchor Drive specifications. Controller uses a 16-bit
processor. Controller operates over the full range 8.5Vdc to 32Vdc with reverse polarity protection. All inputs and outputs
are protected from shorting to ground or the power supply.
4) wire harness - Drive
Wire harness connects the transducers and the Controller to the electrical cables.
5) wire harness - Display
Wire harness provides power to the display and CAN logger via a auxiliary power coupler. Aux power coupler plugs into
the auxiliary (cigarette lighter) port. Wire harness also connects the display and CAN logger to the electrical cable running
to the Anchor Drive wire harness.
6) Transducers
5000 psi capable pressure transducers. 1-5 Volt output. 8-30 Volts supply Voltage. 1-1/4” NPT Male fitting. Packard, 3-
pin electrical connection.
7 & 8) Cables
One 0’ cable and one 20’ cable are provided. Cable is the connection between the Anchor Drive wire harness and the
display wire harness. The cables can be used separately or chained together depending on the required length of cable
needed.
9) Logger Clip
Spring clip mounts the CAN logger to the display bracket.
10) Memory Card
2 GB SD memory card used in the CAN logger. All data recorded during anchor installation will be stored on the SD memory
card. SD card must be formatted in FAT format to work properly. Note SD card must be 2GB or smaller.
11) Mounting Bracket
Display and CAN logger both mount to the bracket. Bracket can be mounted inside the prime movers cab.
12) USB Card Reader
SD memory card inserts into the card reader for download to a laptop or PC via USB port.
13) Suction Cups
Used to mount the mounting bracket to a glass surface inside the prime movers cab.
16) Cable - Secondary Power
Cable will only be needed when an auxiliary power port is not available to power the display unit. The cable will adapt the
auxiliary male connection so that the cable can be run to a power supply such as a battery.
COMPONENT IDENTIFICATION / FUNCTION