Paxton Superchargers 4.6L SOHC Mustang GT User Manual

Page 31

P/N: 4809655

16AUG07 v1.0 96-03MusGT(4809655v1.0)

6-1

A. Inspect all wiring harnesses and electrical connections. Make sure

that all items are properly routed, connected and secured.

B. Check all hoses, lines, and fittings for properly secured connec-

tions.

C. Make certain all fasteners, brackets, and clamps are installed and

properly tightened.

D. Check the serpentine accessory belt and supercharger drive belts

for proper tension and alignment.

E. Cycle ignition key from “off” to the “on” position.
F. Check the entire fuel system for possible leaks.
G. Start the engine and verify that the oil pressure is within normal

range.

H. Allow the engine to come up to normal operating temperature.
I. Check the coolant level in the coolant recovery bottle and top off

as needed.

J. Check for the following:

• Fluid Leaks
• Fluid Levels
• Belt Slippage
• Throttle Response

6.0

CHECK-OUT PROCEDURES

We know that you are anxious to get out and drive your
new vehicle, but please take a little bit more time to
perform these simple check-out steps.

Now that the work is done, it’s time to enjoy the results
of your efforts.

PAXTON Automotive wants to thank

you for choosing our product, and wants to remind you
that the performance and response of your vehicle will
now be different from that to which you have been
accustomed. Please drive cautiously until you feel com-
fortable with the handling of your vehicle.

Please see the service manual included in your kit for
information on the service and maintenance of your
PAXTON Supercharger. Belt tightening, trou-
bleshooting, special tuning requirements, and warranty
information is also included in the Service Manual.