Paxton Superchargers 4.6L SOHC Mustang GT User Manual

Page 11

P/N: 4809655

16AUG07 v1.0 96-03MusGT(4809655v1.0)

1-5

B. Loosen (but do not remove) the four 10mm

bolts on the water pump pulley. (See
Fig. 1.3-b.)

C. Remove the accessory drive belt. Insert a 1/2"

drive ratchet or breaker bar into the square at
the end of the tensioner, and rotate the ten-
sioner. This will relieve the tension on the belt
so it can be removed. It will not be re-used.

D. Using a 13mm wrench, remove the stud bolt

and set it aside. It will not be reused. (See
Figs. 1.3-c, 1.3-d.)

E. Finish removing the four 10mm bolts securing

the water pump pulley and place the pulley
along with its fasteners aside to be reinstalled
in a later step of the installation.

Fig. 1.3-b

F. Use a 13mm socket to remove the idler pulley

located above the belt tensioner. (See Fig.
1.3-d.)

Fig. 1.3-d

Fig. 1.3-c

REMOVE

IDLER PULLEY

13mm

STUD BOLT

13mm

STUD BOLT

Fig. 1.3-e

G. Place the pulley aside to be reused in a later

step.

H. Remove three bolts at the front of the engine

(passenger’s side), (see Fig. 1.3-e), a 10mm
alternator mounting bolt (arrow “A”), and
two 13mm timing cover bolts (arrows “B”
and “C”).