NEXCOM VMC 3000/ 3001 - Manual (Page 46)

Copyright © 2012 NEXCOM International Co., Ltd. All rights reserved 30 VMC 3000/4000 Series User Manual
Chapter 2: System Setup
Installing a WLAN or WWAN module 2. Remove the rear cover of the VMC 3000 series.
The Mini PCI Express slot shown below is used to install a WLAN
module or 3.5G communication module such as GPRS,
UMTS or HSDPA module.
CAUTION! CAUTION! CAUTION!
Prior to removing the chassis cover, make sure the unit’s power is off and
disconnected from the power sources to prevent electric shock or system
damage.
1. Remove these screws and put them in a safe place for later use.
For WWAN module
For WLAN and
WWAN module
4. Install the rear cover.
3. Insert the module into the Mini PCI Express slot at a 45 degrees angle
until the gold-plated connector on the edge of the module completely
disappears inside the slot. And then attach RF cable to the module.