NEXCOM VMC 3000/ 3001 - Manual (Page 20)

Copyright © 2012 NEXCOM International Co., Ltd. All rights reserved 4 VMC 3000/4000 Series User Manual
Chapter 1: Product Introduction
I/O Interfaces - Front
• On screen display buttons x 5
Power on/off
Volume control (+/-)
Brightness control (+/-)
• Light sensor
• 4x LED indicators (Power on/off, Storage, Warning, Shift)
• F1~ F10 functions key
• 2x built-in 2W speakers
I/O Interfaces - Lateral
• 1x CFast card slot
• System reset button
• USB 2.0 host type A connector
I/O Interface-Bottom
VMC 3000/3001
• Power connector (power, ignition, ground)
• 1x RS-232
• 1x RS-232 with either 0, 5 or 12V on pin 9 for external devices
• 2x USB 2.0 host
• 1x 10/100/1000Base-T
• 1x Mic-in, 1x Line-out
• 1x 4GPI and 4GPO or CAN Bus with J1939/J1708 optional
Digital Input (source type; 0~30V)
Digital Output (sink type; 20mA max)
• SMBus to support VTK 61B back up smart battery with charger
• 1x SMA-type GPS antenna connector
I/O Interface-Bottom for VMC4000
• Power connector (power, ignition, ground)
• 1x 6-pin 5V/12V DC output
• 2x USB 2.0 host
• 2x 10/100/1000Base-T
• 1x Mic-in, 1x Line-out
• 1x DB26 Multi-I/O connector
- 1x COM for RS-232/422/485 (default RS-232)
- 1x COM for RS-232 TX/RX
- 1x GPIO (2x DI, 2x DO)
- 2x CAN Bus
- 1x DB9 for RS-232 full
I/O Interface-Bottom for VMC4001
• Power connector (power, ignition, ground)
• 1x Circle type 6-pin CONN for 5V/12V DC output
• 1x Circle type 10pin CONN for CAN Bus x 2 or CAN Bus and GPIO x 2
• 1x Circle type 6pin CONN for Mic-in, 1x Line-out
• 1x Circle type 22pin CONN Multi-I/O connector for
- 1x COM for RS-232/422/485 (default RS-232)
- 1x COM for RS-232 TX/RX
- 1x RS-232 with either 0, 5 or 12V on pin 9 for external devices
• 1x Circle type 8pin CONN for USB 2.0
• 1x Circle type 8pin CONN for Giga LAN x 2
Communication Module
• 1x GPS module
• 1x WLAN and Bluetooth combo module for optional
• 1x WWAN module for optional
Power Management
• Selectable boot-up & shut-down voltage for low power protection
• HW design ready for 8-level delay time on/off at user’s self configuration
• Power on/off ignition, software detectable
• Support S3/S4 suspend mode; wake on RTC/ SMS/ LAN
• Note: LAN wake up function is only available in S3 mode