NEXCOM VMC 3000/ 3001 User Manual
Page 22
Copyright © 2012 NEXCOM International Co., Ltd. All rights reserved
6
VMC 3000/4000 Series User Manual
Chapter 1: Product Introduction
I/O Interface-Bottom
• Power connector (power, ignition, ground)
• 1x RS-232 (VMC 3500 only)
• 1x RS-232 with either 0, 5 or 12V on pin 9 for external devices
• USB 2.0 host (VMC 3501 only one USB)
• 1x 10/100/1000Base-T
• 1x Mic-in, 1x Line-out
• 1x 3GPI and 3GPO or CAN Bus with J1939/J1708 optional
Digital Input (source type; 0~30V)
Digital Output (sink type; 20mA max)
• SMBus to support VTK 61B back up smart battery with charger
• 1x SMA-type GPS antenna connector
Communication Module
• 1x GPS module
• 1x WLAN and Bluetooth combo module for optional
• 1x WWAN module for optional
Power Management
• Selectable boot-up & shut-down voltage for low power protection
• HW design ready for 8-level delay time on/off at user’s self configuration
• Power on/off ignition, software detectable
• Support S3/S4 suspend mode; wake on RTC/ SMS/ LAN
Note: LAN wake up function is only available in S3 mode