Sata configuration, Sata mode – NEXCOM NDiS OPS-M50 User Manual
Page 60
Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.
45
NDiS OPS-M50 User Manual
Chapter 4: BIOS Setup
SATA Configuration
This section is used to configure the SATA drives.
Save & Exit
Advanced
Chipset
Boot
Security
Main
Version 2.02.1205. Copyright (C) 2010 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2010 America Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Determines how SATA
controller(s) operate.
SATA Controller(s)
SATA Mode Selection
Serial ATA Port 0
Software Preserve
Serial ATA Port 1
Software Preserve
[Enabled]
[IDE]
InnoLite SATA (16.0G
SUPPORTED
Empty
Unknown
SATA Mode
IDE Mode
This option configures the Serial ATA drives as Parallel ATA storage devices.
AHCI Mode
This option allows the Serial ATA devices to use AHCI (Ad vanced Host
Controller Interface).
RAID Mode
This option allows you to create RAID or Intel Matrix Stor age configuration
on Serial ATA devices.
Please set SATA Mode to IDE Mode before installing Windows
XP. Setting AHCI mode could not initial Windows XP installation.