beautypg.com

NEXCOM NDiS OPS-M50 User Manual

Page 37

background image

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.

22

NDiS OPS-M50 User Manual

Chapter 3: System Setup

4. Insert the module into the socket at an approximately 30 degrees angle.

Apply firm even pressure to each end of the module until it slips down
into the socket. The contact fingers on the edge of the module will
almost completely disappear inside the socket.

The ejector tabs at the ends of the socket will automatically snap into
the locked position to hold the module in place.

5. Align the mounting holes of the heat sink with the mounting studs on

the board then use the provided mounting screws to secure the heat
sink in place.