Security, Exit, Security exit – NEXCOM NViS 5604-i5 User Manual

Page 73

NViS 5604 Series User Manual

Chapter 4: BIOS Setup

Exit

Advanced

H/W Monitor

Boot

Security

Main

←→: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Option
F1: General Help
F7: Previous Values
F9: Load UEFI Defaults
F10: Save and Exit
ESC: Exit

Set or change the password for
the administrator account.

Only the administrator has
authority to change the settings
in the UEFI Setup Utility. Leave
it blank and press enter to
remove the password.

Supervisor Password

User Password

Supervisor Password

User Password

System Mode state

Secure Boot state

Secure Boot

Not Installed

Setup

Disabled

[Disabled]

Security

Administrator Password
Select this to reconfigure the administrator’s password.

User Password
Select this to reconfigure the user’s password.

Secure Boot
Enables or disables Secure Boot.

Save Changes and Exit

To save the changes and exit, select this field then press . A dialog

box will appear. Confirm by selecting Yes.
Discard Changes and Exit

To exit the Setup utility without saving the changes, select this field then

press . You may be prompted to confirm again before exiting.
Discard Changes

To discard all the changes, select this field then press . A dialog box

will appear. Confirm by selecting Yes.
Load UEFI Defaults

To restore the BIOS to default settings, select this field then press . A

dialog box will appear. Confirm by selecting Yes.

Exit

Advanced

H/W Monitor

Boot

Security

Main

←→: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Option
F1: General Help
F7: Previous Values
F9: Load UEFI Defaults
F10: Save and Exit
ESC: Exit

Exit system setup after saving
the changes.

F10 key can be used for this
operation.

Save Changes and Exit

Discard Changes and Exit

Discard Changes

Load UEFI Defaults

Launch EFI Shell from filesystem device

Exit

This manual is related to the following products:

NViS 5604-i7