NEXCOM NViS 5604-i5 - Manual (Page 64)

Copyright © 2014 NEXCOM International Co., Ltd. All Rights Reserved. 50 NViS 5604 Series User Manual
Chapter 4: BIOS Setup
SATA Controller(s)
Enables or disables the SATA controller.
SATA Mode Selection
Configures the SATA as IDE, AHCI or RAID mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device.
RAID This option allows you to create RAID or Intel Matrix Storage
configuration on Serial ATA devices.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
SATA Aggressive Link Power Management
Enables or disables the SATA aggressive link power management.
Dynamic Storage Accelerator
Enables or disables dynamic storage accelerator, enabling it will increase
HDD and SSD I/O performance.
Hard Disk S.M.A.R.T
Enables or disables hard disk S.M.A.R.T feature.
Storage Configuration
This section is used to configure the storage features.
Advanced
Version 2.15.1234. Copyright (C) 2012 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
←→: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Option
F1: General Help
F7: Discard Changes
F9: Load UEFI Defaults
F10: Save and Exit
ESC: Exit
Enable/disable the SATA
controllers. SATA Controller(s)
SATA Mode Selection
SATA Aggressive Link Power Mgmt
Dynamic Storage Accelerator
Hard Disk S.M.A.R.T
SATA_0 : Not Detected
SATA_1 : WDC WD30EURX-63T0FY0
SATA_4 : Not Detected
SATA_5 : Not Detected
[Enabled]
[AHCI]
[Disabled]
[Enabled]
[Disabled]



