beautypg.com

Primary ide slave – NEXCOM nTUF 600 User Manual

Page 75

background image

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved.

61

nTUF 600 User Manual

Chapter 4: BIOS Setup

Advanced

v02.61 (C) Copyright 1985-2006, American Megatrends, Inc.

BIOS SETUP UTILITY

Select Screen

↑↓

Select Item

+/-

Change Field

Tab

Select Field

F1

General Help

F10

Save & Exit

ESC

Exit

While entering setup, BIOS
auto detects the presence of IDE
devices. This displays the status

of auto detection of IDE devices.

IDE Configuration

ATA/IDE Configuration

Configure SATA as

► Primary IDE Master

► Primary IDE Slave

► Secondary IDE Master

IDE Detect Time Out (Sec)

[Enhanced]

[IDE]

: [TS64GSSD25S-S]

: [TS46GCFX500I]

: [TOSHIBA MK167]

[35]

Advanced

v02.61 (C) Copyright 1985-2006, American Megatrends, Inc.

BIOS SETUP UTILITY

Select Screen

↑↓

Select Item

+/-

Change Field

Tab

Select Field

F1

General Help

F10

Save & Exit

ESC

Exit

Select the type of device
connected to the system.

Primary IDE Slave

Device

:Hard Disk

Vendor :TS4GCFX500I-S

Size :3.9GB

LBA Mode :Supported

Block Mode :Not Supported

PIO :4

Async DMA :MultiWord DMA-2

Ultra DMA :Ultra DMA-6

S.M.A.R.T :Supported

Type

LBA/Large Mode

Block (Multi-Sector Transfer)

PIO Mode

DMA Mode

S.M.A.R.T.

32Bit Data Transfer

[Auto]

[Auto]

[Auto]

[Auto]

[Auto]

[Auto]

[Enabled]

Options

Not Installed

Auto

CD/DVD

ARMD

Primary IDE Slave

This section is used to configure the primary IDE slave device.

Type

Select the type of device connected to the system, the options are
Not Installed, Auto, CD/DVD and ARMD.