NEXCOM NISE 101 User Manual

Page 63

NISE 101 User Manual

Chapter 4: BIOS Setup

ACPI Function

By default, the ACPI function is enabled. This function should be enabled
only in operating systems that support ACPI.

Video Off Method

This determines the manner in which the monitor is blanked.

V/H SYNC + Blank
This selection will cause the system to turn off the vertical and hori-
zontal synchronization ports and write blanks to the video buffer.
Blank Screen
This option only writes blanks to the video buffer.
DPMS
Initializes display power management signaling. Use this option if
your video board supports it.

Video Off In Suspend

This field is used to activate the video off feature when the system enters
the Suspend mode. The options are Yes and No.

MODEM Use IRQ

This field is used to set an IRQ channel for the modem installed in your
system.

Soft-Off by PWR-BTTN

This field allows you to select the method of powering off your system.

Delay 4 Sec.
Regardless of whether the Power Management function is enabled or
disabled, if the power button is pushed and released in less than 4 sec,
the system enters the Suspend mode. The purpose of this function is
to prevent the system from powering off in case you accidentally “hit”
or pushed the power button. Push and release again in less than 4
sec to restore. Pushing the power button for more than 4 seconds will
power off the system.
Instant-Off
Pressing and then releasing the power button at once will immediately
power off your system.

Power On By Ring

Set this field to Enabled to use the modem ring-on function. This will al-
low your system to power-on to respond to calls coming from an external
modem.