Monroe Electronics R189se - Manual (Page 90)

- 85 -
Encoder > General Alerts: Alert Action Table
6.1.1 General EAS
To construct and send an EAS alert, you need to set six items on the General EAS page:
 The EAS alert code;
 The starting time (effective time) of the alert;
 The alert duration
 The FIPS locations codes for the alert;
 The audio message, if any, for the alert.
 The audio announcement message, if any that will precede and follow the alert.
The values for these items are presented using pull-down and selection menus.
Select EAS Code
To set the EAS code, select from the codes presented under the Select Available EAS
Code pull-down menu. The codes shown are the ones that were added to the list on the
Setup >Encoder screen. If the list needs to be corrected, use the link Select Available
EAS Code to return to the Setup > Encoder screen. Configure Available EAS Types for
Encoder as needed. See section 5.9. Then return to the Encoder >Send EAS >General
page to continue constructing the alert.
NOTE: Only specially configured One-Net’s will allow origination of
the National alerts Emergency Action Notification & Termination (EAN
& EAT).