Monroe Electronics R189se - Manual (Page 76)

- 71 -
4.10.4 DVS644 (SCTE18)
If DVS-644 (SCTE 18) is available on the One-Net
SE
, use the Alert Forwarding and/or
the Encoder Alert Send to DVS644 device toggles to enable this protocol for forwarded
alerts and/or originated alerts. At least one of these toggles must be enabled to allow
editing. Accept Changes must be pressed before changes to these toggles are saved.
Setup > Net Alerts > DVS644 (SCTE18)
Alert Forwarding to DVS644/SCTE-18/CEAM devices.
Placing a check in this box will allow Alerts that are received from a Broadcaster to be
forwarded through the One-Net
SE
and sent out using the DVS644 protocol.
Encoder Alert Send to DVS644/SCTE-18/CEAM devices.
Placing a check in this box will allow Alerts that are originated by the One-Net
SE
to be
sent out using the DVS644 protocol.