KLING & FREITAG K&F CD Remote - Manual (Page 19)

User's manual K&F CD 44 Remote
KLING & FREITAG GMBH © 2014 Version 5.5 Page 19 of 50
Status Found: Controller recognised
Loaded: Controller signed on and setup
loaded
Closed: Controller signed off.
Online 2 ) This checkbox is only available for
controllers that are connected with the
computer.
If this checkbox is activated, the device
window opens and the controller can
be operated using the software. It is
no longer visible for other users in the
network.
Offline
2
)
This checkbox is only available for virtual
controllers.
If this checkbox is activated, the device
window opens and the virtual controller
can be operated using the software.
Refer to chapter Working with Virtual
Controllers (Offline Devices) on page
40.
FWRev Firmware version
HWRev Hardware version (circuit boards)
SN Controller’s serial number
2) Devices with extended memory are highlighted in the DeviceList Window.
11. Changing / Saving Device Settings
Changed settings are saved onto the controller in intervals of approx. five seconds so that any
changes to the settings are saved in the case of a loss of power, for example. If you switch off
the controller, these settings remain active. The changes made to the setups, however, are
not saved automatically. You must manually save them after finishing the settings. Refer to
chapter Load and Save Current Setups (Current Setup) on page 21.
11.1 General Procedure for the System Setup
If you want to set up a system configuration, start by mapping the wired hardware in the
software and adjust the setup details afterwards.
Proceed as follows:
1. Select the desired routing.
2. Select the desired input patching.
3. Select the connected speakers.
4. Enter a name for the signal output.
5. Adjust the individual filters, limiters, etc.
6. Create the desired master operating elements.
7. For setups with several controllers, you can save the complete configuration as a scenario.
You can find a detailed description of the system configuration in the hardware manual.