Setting the ip address on the cd 44, Passwords and access rights, 1 setting ip addresses for the pc – KLING & FREITAG K&F CD Remote User Manual
Page 14: 2 setting the ip address on the cd 44
User's manual
K&F CD 44 Remote
KLING & FREITAG GMBH © 2014
Version 5.5
Page 14 of 50
7.4.1
Setting IP Addresses for the PC
1.
On the Windows desktop, go to [Start] » [Settings] » [Control Panel] » [Network
Connections] » [LAN Connection] (double click) » [Properties] » [Internet Protocol (TCP/IP)]
» [Properties] » [Use the following IP address]
2.
Set a fixed IP address (i.e. 192.168.0.100).
The first three digit fields of the computer’s and controller’s IP addresses must be
identical. The last digit field must be different, ranging between 1 and 254. If you
connect several controllers, then each one must have a different final digit field or the
communication will fail. Please do not change the subnet mask address 255.255.255.0
without a special reason.
The controller’s IP address that is set at delivery is 192.168.0.15.
192.168.xxx.xxx is reserved for private networks and is therefore recommended.
3.
Click OK twice to save the changes.
If your system requires dynamic IP addresses, go to 'Alternative Configuration' and enter
the desired address for the controller at User-Defined. This way you can use a static IP
address in a network environment with dynamic addresses. In any case, the controller
itself requires a static IP address.
7.4.2
Setting the IP Address on the CD 44
As an alternative to the steps described above, you can change the IP address of the
controller to match that of your computer. In this case, the first three fields of the IP address
have to match.
1.
Click on Util » IP-Address.
Tip
The new IP address is valid after the controller has been restarted!
8.
Passwords and Access Rights
The controller differentiates between three different authorization modes which called
Master, User, and Lock Mode.
You can find information about changing the passwords and the different modes in
“Changing General Settings (Device)” on page 22.
Administrator Password: The administrator password depends on the serial number and
cannot be changed. It is provided with a sticker on delivery and is required to change the
master and user passwords. If you forget the master password, you can use the administrator
password instead.
Master and User Passwords: The default password for the master mode is 'master', and for
user mode 'user'. Please note the lower case spelling.