KBC Networks WESII - Manual (Page 97)

WESII User Manual
Manual-WESII-Rev1403
Copyright © KBC Networks 2014
Page 96 of 140 www.kbcnetworks.com
10.6 Replacing / Adding a WESII Module from/to the Existing
Application
10.6.1 Replacing a WESII Host unit
The WESII Host/AP connects to its Client(s) based on its MAC Address. A point-to-point
Host/AP can connect to one Client MAC address only. A point-to-multipoint Host/AP can
connect to multiple Clients.
If a Host/AP is being replaced, the Client(s) with which it is required to communicate
must also be re-configured within WESII Client’s System page to ensure that the correct
MAC address is selected for the new Host/AP.
In addition, if adding a new Host/AP to an existing application the Host/AP must be
configured to an available frequency not being used by the existing system.
10.6.2 Replacing a WESII Client unit
If a Client is being replaced, or added to a point-to-multipoint network, it’s SSID,
Country Code and channel spectrum width settings must be configured to match the
Host/ AP configuration with which it wants to connect.
If a Client is being replaced in a point-to-point network see Section 9 to reconfigure the
link.