Junger Audio MIX4 Small Desktop Mixer - Manual (Page 61)

Jünger Audio-Studiotechnik GmbH
page 58
An incoming call (signaled by the GPI) will be shown by that Strip’s channel button blinking dark yellow.
Pressing that button will take that call by closing the Tally and will activate the PFL function so one can listen
to the caller.
The Channel Button will light bright yellow.
The User Button will be blinking green and can be pressed to talkback to the caller.
This function is often called “pre talk”
When the Strip’s fader is then opened, the PFL function will be switched off, the previous monitor source
(normally the bus monitoring of the transmission or recording line) will be selected, and the Channel Button
starts blinking bight yellow to indicate that the call is still active and now on air.
The host can now talk live to the caller through his on air microphone and the opened fader of the
hybrid.
After closing the fader, the hybrid caller is off air.
The channel button is still blinking bright yellow.
One can recall the PFL function by pressing the channel button again to perform a “post talk”
The channel button will light bright yellow again
The User Button will be blinking green and can be pressed to talkback to the caller
If the channel button is now pressed again the GPO Tally signal will be turned off and the hybrid will
terminate the call.